Double layer frosted material jet pipe
2022-05-11 09:58:13
The double-layer abrasive material injection pipe is mainly designed to transport abrasive, sandblasting and shot peening materials. The rubber used inside has excellent wear resistance under the condition of good electrical conductivity, and the pipe body transports many media. It has strong friction, this type of choice can well protect the use of the pipe body, and the rubber used in the outer layer has good wear resistance and oxidation resistance. The design is rare in China, it can well protect the use of the tube body and prolong the service life. Litong low-pressure hose series includes Jiabu low-pressure hoses with oil resistance, acid and alkali resistance, steam, wear resistance, etc., which meet customer requirements and make customers more trustworthy. Acid and alkali resistant hoses
1. Composition: The acid and alkali transport pipe is composed of inner rubber layer, adhesive cloth layer and outer rubber layer.
2. Performance and use: This type of hose is suitable for conveying dilute acid (acid) solution when the concentration is below 40% under positive pressure conditions (it can be adapted to 40% sulfuric acid, 30% hydrochloric acid, 15% sodium hydroxide, but nitric acid is excluded) use. Applicable temperature range: the ambient temperature is 20 to 45 °C; the temperature of the conveying medium is not higher than 45 °C.
The purpose of heat preservation of the hose for transporting high-temperature gas: 1. To avoid heat loss of the gas in the pipeline, especially the air-conditioning system in winter; 2. To avoid blocking the release of heat into the room when transporting waste heat steam or high-temperature gas to increase the indoor temperature. Avoid personal injury by touching the air duct. In summer, when the temperature of the transport gas is lower than the dew point temperature of the outside gas, condensation will occur on the outer wall of the pipeline. This will increase the loss of cooling capacity for the air ducts of the central air conditioning system, and at the same time, condensed water droplets will pollute the ceiling and walls and floors, so cold insulation treatment should also be carried out. The mud pump is a kind of reciprocating plunger pump, which converts the rotary motion into the reciprocating linear motion of the crosshead and the piston through the crank connecting rod mechanism, and compresses the low-pressure mud into high-pressure mud. During the drilling process, the drilling fluid with high viscosity, high specific gravity and high sand content is transported to the bottom of the well at high pressure to cool the drill bit, flush the bottom of the well, break the rock, and carry out cuttings when returning from the bottom of the well. It is an oil drilling operation. One of the most important process equipment.
After the oil is extracted, it must be transported to the corresponding processing department in order to be better utilized, and the oil pipeline for transporting oil is an essential equipment. The existing oil hose is a straight pipe structure. Due to the viscosity of the oil itself, it is easy to stick to the pipe wall, causing blockage and inconvenience to oil transportation.
The content about -Oil Hoses- is relatively small, and we will gradually update it later, so stay tuned.
Tags you may be concerned about: Oil Hoses Related tags Articles: Oil Hoses (22)